2000 suppliers in 1,000,000 net square feet of exhibit space.

One of them, in booth #6022, will be Paratherm Corporation.

Why do you want to take the time to visit Paratherm's booth?

If you use hot oil, you won't want to miss it. Not because we're doing anything especially fancy for the show, or giving away rotomolded plastic rowboats (how do they get that stuff home anyway?) but because we know just about everything you need to know about hot oil and it's application in the plastic industry.

Want to hear how seal pots prevent hot-oil oxidation?  About reversible pump units that make tool changing easier?  The pros and cons of negative pressure hot oil units?  Component differences in water/glycol units vs. oil units?  Hot-oil-unit cleaners? Booth 6022, June 19-23, will be the place and time to hear about it.

If you haven't already, visit our Plastics Industry page for some short case histories of our successful relationships with molders, extruders and other plastics processors. There, we report on hot-oil temperature control in a plastics additive manufacturing process (Polyvisions), in a short-run plastics part shop (Urgent Plastics) and at a compounder making fluoroelastomer compounds for automotive and aerospace products (AGC Chemicals.)

Come to the booth, visit us, and tell us your story.

Featured New Product: Paratherm MG™ Mid-Range Heat Transfer Fluid (for Blowmolding)

At McCormick Place, Paratherm's Booth 6022 is in North Hall, Level 3, Section B1. Near the SPI pavilion, between Omega Tool (6020) and Printex (6023)

LOOK FOR THIS BOOTH

Paratherm has hosted exhibits at NPE since 1991.

RELATED ARTICLES